Belden / Krone Data Cabling Approved Materials
For
Moves, Adds, and Changes in Existing Buildings Previously Cabled with Like-materials
Established March 4, 2004
The standard wiring configuration for Data outlets is T568B.
Materials required for data installations may include, but are not limited to:
Belden 1700A Blue DataTwist 350 Data Cable, blue or
Belden GigaFlex 1200 Data Cable, blue
ADC/Krone 6467 5 181-20 Category 5e Jack, white
ADC/Krone 6467 1 095-20 USOC Voice Jack, white
ADC/Krone 6644 1 174-01 Angled Faceplate, white
ADC/Krone 6644 1 224-01 4-Port All-Fit Box, white
ADC/Krone 6644 1 107-20 4-port 106 Adaptor, white
ADC/Krone 6644 1 165-20 4-port Walker 500-series Faceplate, white
ADC/Krone 6644 1 144-01 4-Port Modular Furniture Faceplate, white
ADC/Krone 6645 1 160-01 Blanks, white
ADC/Krone 6653 1 585-24 24-Port Patch Panel, black
ADC/Krone 6653 2 701-02 Horizontal Cable Organizer, black
ICC Horizontal Cable Management channel, black, ICCMSCMA52
Belden patch cords for patch panel end, blue (24 ea. per patch panel provided)
Belden 10ft. patch cords for station end, gray (24 ea. per patch panel provided)
CADDY CableCat or equivalent J-hooks for supporting of cables
Panduit or Wiremold surface cable raceway, white finish
CADDY, Arlington,
or equal single-gang low voltage mounting bracket (after-set ring).
If raceway outlets
are required for new lab:
Wiremold® 5400TBWH white finish two-compartment surface raceway
5400CWH full width covers
MXN2A08WH corner drop raceway base & cover (for vertical corner feed)
5410DFOWH divided entrance end
5411FOWH flat elbow
5415WH full capacity tee
5417FOWH internal elbow
5418WH external elbow
MXN2F21WH corner entrance fitting (for vertical corner feed)
5408LWH left transition fitting (for MXN2A08WH corner drop)
5408RWH right transition fitting (for MXN2A08WH corner drop)
5410WH end cap (for raceway ends)
5450WH device brackets (for mounting power outlets and data end plates)
CM-EPLA-WH end plates (to receive up to 3 CM2-U2NOR-WH modules)
CM2-U2NOR-WH Belden/CDT unloaded modules (to hold 2 Belden jacks)
CM2-BLWH blank insert (for unused openings of end plates)
5507DWH duplex faceplates (for electrical duplex, 1 per end plate)
5507BWH blank faceplates (for all unused openings of device brackets)
and all additional required fittings.
Use Belden AX101065 PS6+ data jacks for 5400-series raceway
All listed Wiremold components are white
finish (WH suffix added to catalog number)
See additional installation standards here